Just got a new Woods propane stove..yippee!
However, the control knobs are a bit tight..not hard to turn, but they spring back a little bit when you rotate them.
The question is......should I put a drop of WD40 or similar down the control shafts, or is there an O-ring that will get damaged by the oil?
Here is a pic for reference.........
http://www.canadiantire.ca/browse/pr...6#BVQAWidgetID
However, the control knobs are a bit tight..not hard to turn, but they spring back a little bit when you rotate them.
The question is......should I put a drop of WD40 or similar down the control shafts, or is there an O-ring that will get damaged by the oil?
Here is a pic for reference.........
http://www.canadiantire.ca/browse/pr...6#BVQAWidgetID
Comment